Remove all parts from the shipping bag and place as shown in picture to right of
paragraph.
Remove all stock chain guard and splash guard pieces; save all mounting
bolts. See picture to right of paragraph.
Install clip mounts on top run of WUDO inside guard and install between
wheel and sprocket from the top, above the swingarm.
Fasten u-bracket to the WUDO inside guard with 4 nuts and bolts supplied in
package. Loosely install stock bolts to fasten u-bracket to the swing-arm at
three locations just in front of the rear axle nut. Note: one bolt on the top
side of the swingarm and two on the bottom edge of the swingarm. See photo to
right of paragraph.
Remove right side chain adjusting bolt and discard. Install WUDO chain wwheel cover and WUDO adjusting bolt. Note: refer to picture #1 and picture #3.
Insert clip nuts on cover and fasten to inside guard with the nuts supplied. Adjust chain carefully and check that chain does not rub on guard or hardware.
Remove bolts holding u-brackets to swing arm and install stock splash guard
assemblies over u-bracket using stock bolts. Tighten all bolts on left and right
sides of swingarm. Drill two holes in upper run of stock chain guard to align
with WUDO clip nuts on upper run of inside guard. Inset bolts supplied and
tighten to fasten the top of the stock guard to the top of the WUDO inside
guard. See photo to right of paragraph. Of course, check all your work; spin the
wheel to check for clearances, etc. Test ride.
